Yavari (ship)

Construction

In 1862 Thames Ironworks in West Ham built the iron-hulled Yavari and Yapura under contract to the James Watt Foundry of Birmingham. The ships were designed as combined cargo, passenger and gunboats for the Peruvian Navy.

The ships were built in "knock down" form; that is, they were assembled with nuts and bolts at the shipyard, dismantled into thousands of parts small enough to transport, and shipped to their final destination to be assembled with rivets and launched on the lake. The kits for the two ships consisted of a total of 2,766 pieces between them. Each piece was no more than 3.5. cwt—what a mule could carry—because the railway from the Pacific Ocean port of Arica went only 40 mi, as far as Tacna. From there pack mules had to carry them the remaining 220 mi to Puno on the lake at 3,812 metres above the sea level.

The original British contractor got the parts to Tacna but failed to complete the section of the journey with mules. This was not resumed until 1868 and the first plates for Yavaris hull were laid at Puno in 1869. Yavari was launched in 1870 and Yapura in 1873.

Yavari was 100 ft long and had a 60 hp two-cylinder steam engine, which was fuelled with dried llama dung.

In 1914, Yavaris hull was extended in 15 meters to increase her cargo capacity. At the same time she was re-engined as a motor vessel with a Bolinder four-cylinder 320 bhp hot bulb engine.

Service history

Even though peace had already been signed with the Treaty of Ancón between Peru and Chile to end the War of the Pacific on October 20, 1883, Rear Admiral Lizardo Montero and General César Canevaro resisted in Arequipa. Pursued by Chilean forces, they retreat to Puno and negotiate more support from Bolivia. Upon reaching Puno, on the shore of Titicaca, they boarded with their men the steam gunboats Yavarí and Yapurá, to march towards the lake port of Chililaya, in Bolivia, where General Narciso Campero was waiting for him with two Bolivian battalions to resume hostilities against Chile.

However, a Chilean division arrived in Puno on November 4, 1883 and its local authorities immediately handed over the place, declaring themselves in favor of peace and the government of Miguel Iglesias. The Chilean forces transported by rail from the port of Mollendo to Puno the torpedo boat Colo Colo and launched there into the waters of Lake Titicaca, where it carried out patrolling operations to prevent communications, control the guerrillas and the military use of the lake.

The end of the Pacific War came with an impoverished Peruvian government, so in 1890 UK investors established the Peruvian Corporation which took over the concession to operate Peru's railways and lake ships. and renamed her BAP Puno but discarded Yavari.

In 1987 charitable interests bought Yavari to restore her. She is now moored at Puno Bay where she provides static tourist accommodation while undergoing full restoration. In 2015, with restoration almost complete, a group of young East Enders sponsored by the West Ham United Foundation trekked over the Andes from Tacna to Puno following the original route of the Yavari. With historian Stephen Pewsey they participated in a "second maiden voyage" on Lake Titicaca, accompanied by the British Ambassador to Peru, H.E. Anwar Choudhury.

References

References

1. "History of The Ship". The Yavari Project.
2. (2007-11-11). "Condecoran al BAP Puno por seguir prestando servicio". Empresa Editora El Comercio S.A..