Surf Wiki
Save to docs
general/radiation-health-effects

From Surf Wiki (app.surf) — the open knowledge base

Wipe test counter

A wipe test counter is a device used to measure for possible radioactive contamination in a variety of environments. When using radioactive materials it is necessary to test for accidental contamination, whether from use of liquid unsealed sources or to check for leaking sealed sources. A swab or small absorbent smear can be used to “wipe” an area, the wipe is then placed into a test tube and counted, typically using a gamma counter. Testing for leaks in this manner is a method described in the ISO 9978 standard.

Equipment

Survey instruments may be used to detect surface contamination without requiring wiping, however this requires careful calibration and technique to ensure adequate sensitivity is achieved.

A gamma counter is a typical choice for measuring wipe samples for radioactivity as it allows multiple tests to be counted in a largely automated way. These systems detect radiation using a scintillator and photomultiplier tube and may allow the energy spectrum of a sample to be recorded, which can be used to identify the contaminant.

Use of a gamma camera has also been proposed, where collimators are removed to improve sensitivity.

Regulation

Wipe testing is typically a requirement of licenses to hold radioactive materials. In the United States the Nuclear Regulatory Commission requires wipe testing of sealed sources "periodically" using equipment sensitive down to 185 Becquerels. In the United Kingdom the Health and Safety Executive guidance for the Ionising Radiations Regulations 1999 requires wipe testing (usually every two years) and it is also likely to be a requirement of Environment Agency permits. In Australia licence conditions may require adherence to Australian standard AS2243.4 and ISO 9978 for wipe testing of sealed sources.

References

References

  1. "ISO 9978:1992 Radiation protection -- Sealed radioactive sources -- Leakage test methods".
  2. (12 April 1993). "Information Notice No. NO. 93-30: NRC Requirements for Evaluation of Wipe Test Results; Calibration of Count Rate Survey Instruments".
  3. (1990). "The Foundations of Laboratory Safety a Guide for the Biomedical Laboratory". Springer New York.
  4. (2006). "Radiation Safety in Nuclear Medicine.". CRC Press.
  5. (1990). "Gamma Camera and Computer-Assisted Wipe Tests: A Simple Method". Journal of Nuclear Medicine Technology.
  6. "10 CFR 39.35 Leak testing of sealed sources.".
  7. (2000). "Work with ionising radiation : Ionising Radiations Regulations 1999 approved code of practice and guidance". HSE Books.
  8. (2011). "Sealed sources: how to comply with your EPR RSR environmental permit".
  9. (February 2013). "Wipe Testing of Sealed Sources & Use of Sealed Sources Beyond Recommended Working Life".
Info: Wikipedia Source

This article was imported from Wikipedia and is available under the Creative Commons Attribution-ShareAlike 4.0 License. Content has been adapted to SurfDoc format. Original contributors can be found on the article history page.

radiation-health-effects particle-detectors
Want to explore this topic further?

Ask Mako anything about Wipe test counter — get instant answers, deeper analysis, and related topics.

Research with Mako

Free with your Surf account

Content sourced from Wikipedia, available under CC BY-SA 4.0.

This content may have been generated or modified by AI. CloudSurf Software LLC is not responsible for the accuracy, completeness, or reliability of AI-generated content. Always verify important information from primary sources.

Report