Surf Wiki
Save to docs
general/critical-phenomena

From Surf Wiki (app.surf) — the open knowledge base

Upper critical solution temperature

Critical temperature of miscibility in a mixture

Upper critical solution temperature

Critical temperature of miscibility in a mixture

The upper critical solution temperature (UCST) or upper consolute temperature is the critical temperature above which the components of a mixture are miscible in all proportions. The word upper indicates that the UCST is an upper bound to a temperature range of partial miscibility, or miscibility for certain compositions only. For example, hexane-nitrobenzene mixtures have a UCST of 19 C, so that these two substances are miscible in all proportions above 19 C but not at lower temperatures. Examples at higher temperatures are the aniline-water system at 168 C (at pressures high enough for liquid water to exist at that temperature), and the lead-zinc system at 798 C (a temperature where both metals are liquid).

A solid state example is the palladium-hydrogen system which has a solid solution phase (H2 in Pd) in equilibrium with a hydride phase (PdHn) below the UCST at 300 °C. Above this temperature there is a single solid solution phase.

In the phase diagram of the mixture components, the UCST is the shared maximum of the concave down spinodal and binodal (or coexistence) curves. The UCST is in general dependent on pressure.

The phase separation at the UCST is in general driven by unfavorable energetics; in particular, interactions between components favor a partially demixed state.

Polymer-solvent mixtures

A plot of typical polymer solution phase behavior including a UCST

Main article: Temperature-responsive polymer

Some polymer solutions also have a lower critical solution temperature (LCST) or lower bound to a temperature range of partial miscibility. As shown in the diagram, for polymer solutions the LCST is higher than the UCST, so that there is a temperature interval of complete miscibility, with partial miscibility at both higher and lower temperatures.

The UCST and LCST of polymer mixtures generally depend on polymer degree of polymerization and polydispersity.

The seminal statistical mechanical model for the UCST of polymers is the Flory–Huggins solution theory.

By adding soluble impurities the upper critical solution temperature increases and lower critical solution temperature decreases.

References

References

  1. "IUPAC Compendium of Chemical Terminology".
  2. "Atkins' Physical Chemistry 8e (2006)".
  3. (1982). "Physical chemistry". [[Benjamin/Cummings Pub. Co.]].
  4. (November 1978). "Statistical Thermodynamics of Polymer Solutions and Blends". [[ACS Publications]].
  5. Cowie, J. M. G. (1991). "Polymers: chemistry and physics of modern materials". Blackie; Chapman and Hall.
  6. (1985-10-01). "UCST and LCST behavior in polymer blends". Macromolecules.
  7. Robeson, Lloyd. (April 30, 2014). "Historical Perspective of Advances in the Science and Technology of Polymer Blends". [[Polymers]].
  8. Rice, O. K.. (June 1976). "The effect of an impurity on the critical point of a binary liquid system as a surface phenomenon". [[The Journal of Chemical Physics]].
Info: Wikipedia Source

This article was imported from Wikipedia and is available under the Creative Commons Attribution-ShareAlike 4.0 License. Content has been adapted to SurfDoc format. Original contributors can be found on the article history page.

critical-phenomena
Want to explore this topic further?

Ask Mako anything about Upper critical solution temperature — get instant answers, deeper analysis, and related topics.

Research with Mako

Free with your Surf account

Content sourced from Wikipedia, available under CC BY-SA 4.0.

This content may have been generated or modified by AI. CloudSurf Software LLC is not responsible for the accuracy, completeness, or reliability of AI-generated content. Always verify important information from primary sources.

Report