Tin selenide

Structure

α-SnSe is classified as a layered metal chalcogenide. It includes a group 16 anion (Se2−) and an electropositive element (Sn2+), and is arranged in a layered structure. Tin(II) selenide (SnSe) crystallizes in the orthorhombic structure that is related to the rock-salt structure. It is isomorphous to germanium selenide (GeSe). The unit cell encompasses two inverted layers. Each tin atom is covalently bonded to three neighboring selenium atoms, and each selenium atom is covalently bonded to three neighboring tin atoms. The layers are held together primarily by van der Waals forces. At temperatures above 800 K its structure changes to rock-salt structure.

7 coordination polyhedra, which have three short and four very long Sn–Se bonds, and a lone pair of the Sn2+ sterically accommodated between the four long Sn–Se bonds. The two-atom-thick SnSe slabs are corrugated, creating a zig-zag accordion-like projection along the b axis. The easy cleavage in this system is along the (100) planes. While cooling from its high-temperature, higher symmetry phase (space group Cmcm, #63), SnSe undergoes a displacive (shear) phase transition at ~750–800 K, resulting in a lower symmetry Pnma (#62) space group. Owing to this layered, zig-zag accordion-like structure, SnSe demonstrates low anharmonicity and an intrinsically ultralow lattice thermal conductivity, making SnSe one of the world's least thermally conductive crystalline materials. The fundamental mechanism of the low thermal conductivity has been elaborated in this "soft" accordion-like layered structure and verified due to a abnormally strong phonon renormalization at room temperature.

-- At pressures above 58 GPa, SnSe acts as a superconductor; this change of conductivity is likely due to a change in the structure to that of CsCl. Another polymorph is based upon the cubic and orthorhombic crystal system is known as π-SnSe (space group: P213, No. 198). A γ-SnSe phase has also been reported (space group: Pnma, No. 62).

Synthesis

Tin(II) selenide can be formed by combining the elements tin and selenium above 350 °C.

Problems with the composition are encountered during synthesis. Two phases exist—the hexagonal SnSe2 phase and the orthorhombic SnSe phase. Specific nanostructures can be synthesized, but few 2D nanostructures have been prepared. Both square SnSe nanostructures and single-layer SnSe nanostructures have been prepared. Historically, phase-controlled synthesis of 2D tin selenide nanostructures is quite difficult.

Sheet-like nanocrystalline SnSe with an orthorhombic phase has been prepared with good purity and crystallization via a reaction between a selenium alkaline aqueous solution and tin(II) complex at room temperature under atmospheric pressure. A few-atom-thick SnSe nanowires can be grown inside narrow (~1 nm diameter) single-wall carbon nanotubes by heating the nanotubes with SnSe powder in vacuum at 960 °C. Contrary to the bulk SnSe, they have the cubic crystal structure.

Use in energy harvesting

Tin(II) selenide has been considered for thermoelectric applications. SnSe has exhibited the highest thermoelectric material efficiency, measured by the unitless ZT parameter, of any known material (~2.62 at 923 K along the b axis and ~2.3 along the c axis). When coupled with the Carnot efficiency for heat conversion, the overall energy conversion efficiency of approximately 25%. Its high efficiency is most likely due to low thermal conductivity of the crystal, the electronic structure may have as important role: SnSe has highly anisotropic valence band structure, which consists of multiple valleys that act as independent channels for very mobile, low effective-mass charge transport within, and heavy-carrier conductivity perpendicular to the layers. While, historically, lead telluride and silicon-germanium have been used, these materials suffer from high thermal conductivity.

At room temperature, the crystal structure of SnSe is Pnma. However, at ~750 K, it undergoes a phase transition that results in a higher symmetry Cmcm structure. This phase transition preserves many of the advantageous transport properties of SnSe. The dynamic structural behavior of SnSe involving the reversible phase transition helps to preserve the high power factor. The Cmcm phase, which is structurally related to the low temperature Pnma phase, exhibits a substantially reduced energy gap and enhanced carrier mobilities while maintaining the ultralow thermal conductivity thus yielding the record ZT. Because of SnSe's layered structure, which does not conduct heat well, one end of the SnSe single crystal can get hot while the other remains cool. This idea can be paralleled with the idea of a posture-pedic mattress that does not transfer vibrations laterally. In SnSe, the ability of crystal vibrations (also known as phonons) to propagate through the material is significantly hampered. This means heat can only travel due to hot carriers (an effect that can be approximated by the Wiedemann–Franz law), a heat transport mechanism that is much less significant to the total thermal conductivity. Thus the hot end can stay hot while the cold end remains cold, maintaining the temperature gradient needed for thermoelectric device operation. The poor ability to carry heat through its lattice enables the resulting record high thermoelectric conversion efficiency. The previously reported nanostructured all-scale hierarchical PbTe-4SrTe-2Na (with a ZT of 2.2) exhibits a lattice thermal conductivity of 0.5 W m−1 K−1. The unprecedentedly high ZT ~2.6 of SnSe arises primarily from an even lower lattice thermal conductivity of 0.23 W m−1 K−1. However, in order to take advantage of this ultralow lattice thermal conductivity, the synthesis method must result in macroscale single crystals as p-type polycrystalline SnSe has been shown to have a significantly reduced ZT. Enhancement in the figure of merit above a relatively high value of 2.5 can have sweeping ramifications for commercial applications especially for materials using less expensive, more Earth-abundant elements that are devoid of lead and tellurium (two materials that have been prevalent in the thermoelectric materials industry for the past couple decades).

Other possible uses

Tin selenides may be used for optoelectronic devices, solar cells, memory switching devices, and anodes for lithium-ion batteries.

Tin(II) selenide has potential as a solid-state lubricant, due to the nature of its interlayer bonding. It is not the most stable of the chalcogenide solid-state lubricants, as tungsten diselenide has much weaker interplanar bonding, is highly chemically inert and has high stability in high-temperature, high-vacuum environments.

References

References

1. "Supplementary Information - Facile chemical synthesis and enhanced thermoelectric properties of Ag doped SnSe nanocrystals".
2. Persson, Kristin. (2014). "Materials Data on SnSe (SG:62) by Materials Project". LBNL Materials Project; Lawrence Berkeley National Laboratory (LBNL), Berkeley, CA (United States).
3. (2014). "Ultralow thermal conductivity and high thermoelectric figure of merit in SnSe crystals". Nature.
4. (2019). "Intrinsic Low Thermal Conductivity and Phonon Renormalization Due to Strong Anharmonicity of Single-Crystal Tin Selenide". Nano Letters.
5. (2014). "Two-Dimensional Tin Selenide Nanostructures for Flexible All-Solid-State Supercapacitors". ACS Nano.
6. (1996). "Benzyl-Substituted Tin Chalcogenides. Efficient Single-Source Precursors for Tin Sulfide, Tin Selenide, and Sn(S_xSe_1−x) Solid Solutions". Chemistry of Materials.
7. (1978). "Refinement of the structures of GeS, Ge ''Se'', SnS and Sn ''Se''". Zeitschrift für Kristallographie.
8. (1990). "Core excitons and conduction-band structures in orthorhombic GeS, Ge ''Se'', SnS, and Sn ''Se'' single crystals". Physical Review B.
9. (1997). "Superconductivity of tin selenide at pressures up to 70 GPa". Physics of the Solid State.
10. (2016). "A new nanocrystalline binary phase: synthesis and properties of cubic tin monoselenide". CrystEngComm.
11. (2021). "A new binary phase in the tin monoselenide system: chemical epitaxy of orthorhombic γ-SnSe thin films". Materials Chemistry Frontiers.
12. {{Greenwood&Earnshaw1st
13. (20 March 2018). "Nanostructured SnSe: Synthesis, doping, and thermoelectric properties". American Institute of Physics.
14. (2000). "Room temperature growth of nanocrystalline tin (II) selenide from aqueous solution". Journal of Crystal Growth.
15. (2014). "Band gap expansion, shear inversion phase change behaviour and low-voltage induced crystal oscillation in low-dimensional tin selenide crystals". Dalton Trans.
16. (2019). "High-performance solution-processable flexible SnSe nanosheet films for lower grade waste heat recovery". Advanced Electronic Materials.
17. (2018). "Band structure of a IV-VI black phosphorus analogue, the thermoelectric SnSe". Physical Review Letters.
18. (2008). "Complex thermoelectric materials". Nature Materials.
19. [http://phys.org/news/2014-04-tin-selenide-efficiently-electrical-energy.html Researchers find tin selenide shows promise for efficiently converting waste heat into electrical energy]. phys.org (April 17, 2014)
20. (2014). "Ultralow thermal conductivity and high thermoelectric figure of merit in Sn ''Se'' crystals". Nature.
21. (2014). "Thermoelectric properties of p-type polycrystalline Sn ''Se'' doped with Ag". Journal of Materials Chemistry A.
22. (2008). "Crystal Chemistry and Solid Lubricating Properties of the Monochalcogenides Gallium Selenide and Tin Selenide". Tribology Transactions.