From Surf Wiki (app.surf) — the open knowledge base

Pioneer 2

Failed NASA mission to the Moon (1958)

Field	Value
name	Pioneer 2
image	Pioneer able.png
image_size	300px
image_caption	The lunar orbiter Pioneer 2.
mission_type	Lunar orbiter
operator	NASA
mission_duration
Failed to orbit
suborbital_apogee	1550 km
manufacturer	Space Technology Laboratories
launch_mass	39.2 kg
launch_date	GMT
launch_rocket	Thor DM 18-Able I
launch_site	Cape Canaveral, LC-17A
decay_date	GMT
instruments_list
acronym1		name1 = Ionization Chamber
acronym2		name2 = Magnetometer
acronym3		name3 = Temperature Sensors
acronym4		name4 = Micrometeoroid Sensor
acronym5		name5 = Proportional Counter Telescope
acronym6		name6 = Television System
programme	Pioneer program
previous_mission	Pioneer 1
next_mission	Pioneer 3

Failed to orbit

Pioneer 2 (also known as Able 3) was the last of the three project Able space probes designed to probe lunar and cislunar space.

Spacecraft design

Pioneer 2 (NSSDCA ID: PION2) was nearly identical to Pioneer 1. It consisted of a thin cylindrical midsection with a squat truncated cone frustum on each side. The cylinder was 74 cm in diameter and the height from the top of one cone to the top of the opposite cone was 76 cm. Along the axis of the spacecraft and protruding from the end of the lower cone was a 11 kg solid propellant injection rocket and rocket case, which formed the main structural member of the spacecraft. Eight small low-thrust solid propellant velocity adjustment rockets were mounted on the end of the upper cone in a ring assembly which could be jettisoned after use. A magnetic dipole antenna also protruded from the top of the upper cone. The shell was composed of laminated plastic. The total mass of the spacecraft after vernier separation but before injection rocket firing was 39.5 kg.

The scientific instrument package had a mass of 15.6 kg (34.4 lb) and consisted of an STL image-scanning television system (which replaced the NOTS (Naval Ordnance Test Station) image scanning infrared television system on Pioneer 1), a proportional counter for radiation measurements, an ionization chamber to measure radiation in space, a diaphragm/microphone assembly to detect micrometeorites, a spin-coil magnetometer to measure magnetic fields to 5 microgauss, and temperature-variable resistors to record spacecraft internal conditions.

Pioneer 2 trajectory and viewing possibilities

The spacecraft was powered by nickel-cadmium batteries for ignition of the rockets, silver cell batteries for the television system, and mercury batteries for the remaining circuits. The radio transmission was at 108.06 MHz through a magnetic dipole antenna for the television system, telemetry, and doppler. Ground commands were received at 115 MHz.

The spacecraft was to be spin-stabilized at 1.8 revolutions per second, the spin direction approximately perpendicular to the geomagnetic meridian planes of the trajectory.

Flight

The launch took place at 07:30:21 GMT on 8 November 1958. After Pioneer 1 had failed due to guidance system deficiencies, the guidance system was modified with a Doppler command system to ensure more accurate commands and minimize trajectory errors. Once again, the first and second stage portion of the flight was uneventful, but the third stage of the launch vehicle failed to ignite, making it impossible for Pioneer 2 to achieve orbital velocity.

An attempt to fire the vernier engines on the probe was unsuccessful and the spacecraft attained a maximum altitude of 1550 km before reentering Earth's atmosphere at 28.7° N, 1.9° E over NW Africa.

A small amount of data was obtained during the short flight, including evidence that the equatorial region around Earth has higher flux and higher energy radiation than previously considered and that the micrometeorite density is higher around Earth than in space.

The reason for the third stage failure was unclear, but it was suspected that the firing command from the second stage, which contained the guidance package for the entire launch vehicle, was never received, possibly due to damage to electrical lines during staging.

References

| access-date= 20 February 2021 }}

| access-date= 18 August 2023 }}

| access-date = 17 February 2009 | archive-url= https://web.archive.org/web/20211019050852/https://www.sdfo.org/stl/1958%20NASA%20USAF%20Space%20Probes%20%28ABLE-1%29%20FINAL%20REPORT.pdf | archive-date= 19 October 2021 }}

| access-date= 17 February 2009 | archive-date= 12 April 2022 | archive-url= https://web.archive.org/web/20220412164626/https://ntrs.nasa.gov/citations/19990008156 | url-status = live }}

Info: Wikipedia Source

This article was imported from Wikipedia and is available under the Creative Commons Attribution-ShareAlike 4.0 License. Content has been adapted to SurfDoc format. Original contributors can be found on the article history page.

spacecraft-launched-in-1958 missions-to-the-moon pioneer-program spacecraft-which-reentered-in-1958 space-missions-that-ended-in-failure

Want to explore this topic further?

Ask Mako anything about Pioneer 2 — get instant answers, deeper analysis, and related topics.

Research with Mako

Free with your Surf account

Content sourced from Wikipedia, available under CC BY-SA 4.0.

This content may have been generated or modified by AI. CloudSurf Software LLC is not responsible for the accuracy, completeness, or reliability of AI-generated content. Always verify important information from primary sources.

Report