External water spray system

Usage

The types of systems vary greatly from a single impact sprinkler placed on a roof, systems installed during construction with sprays on all windows and doors, and small sprays damping gutters. Some are installed using copper piping and sprays while others use common PVC piping.

Usage depends on type of risk and belief of effectiveness. Copper piping is used to withstand high temperatures that may be experienced during a fire front or for higher reliability for in ceiling installations. External PVC piping is used where failure with exposure to high radiant heat is acceptable, as at the time the system is considered have "done its job". This is a matter of personal judgment.

Issues

There is a lack of scientific research regarding EWSS. Other issues that may affect the effectiveness of an EWSS:

• Sprinkler performance in high wind conditions typical in a bushfire
• Home design
  • High vulnerability areas. e.g. decking
  • Garden beds near walls
  • Window sills
  • Large windows (heat radiation)
  • Internal furnishings (e.g. curtains)
• Home location
  • Slope
  • Surrounding vegetation
• If defended by occupiers
• Preparation (if prepared for defense)
• If intended for remote (unattended) defense
• Available water supply
• Ember attack
• Fire front (radiant heat)
• Adjacent building or vegetation fire

Types

• Roof impact sprinkler
• Gutter sprays
• Window spray / deluge

Commercial sprays designed for EWSS are available, but most systems use commonly available irrigation sprinklers/sprays.

Research

External spray systems for buildings are well documented for protection from fires in adjacent buildings. However, up there is little published scientific research on scientific information pertaining to the effectiveness of EWSS under varying wildfire conditions.

References

References

1. "Report from FPA on EWSS after 2003 bushfires, Fire Protection Association Australia (FPAA) ''External Water Spray Systems to Aid Building Protection from Wildfire''".