From Surf Wiki (app.surf) — the open knowledge base
Deep-focus earthquake
Earthquake with a hypocenter depth exceeding 300 km
Earthquake with a hypocenter depth exceeding 300 km
A deep-focus earthquake in seismology (also called a plutonic earthquake) is an earthquake with a hypocenter depth exceeding 300 km. They occur almost exclusively at convergent boundaries in association with subducted oceanic lithosphere. They occur along a dipping tabular zone beneath the subduction zone known as the Wadati–Benioff zone.
Discovery
Preliminary evidence for the existence of deep-focus earthquakes was first brought to the attention of the scientific community in 1922 by Herbert Hall Turner. In 1928, Kiyoo Wadati proved the existence of earthquakes occurring well beneath the lithosphere, dispelling the notion that earthquakes occur only with shallow focal depths.
Seismic characteristics
Deep-focus earthquakes give rise to minimal surface waves. Their focal depth causes the earthquakes to be less likely to produce seismic wave motion with energy concentrated at the surface. The path of deep-focus earthquake seismic waves from focus to recording station goes through the heterogeneous upper mantle and highly variable crust only once. Therefore, the body waves undergo less attenuation and reverberation than seismic waves from shallow earthquakes, resulting in sharp body wave peaks.
Focal mechanisms
The pattern of energy radiation of an earthquake is represented by the moment tensor solution, which is graphically represented by beachball diagrams. An explosive or implosive mechanism produces an isotropic seismic source. Slip on a planar fault surface results in a double-couple source. Uniform outward motion in a single plane due to normal shortening is known as a compensated linear vector dipole source.
Physical process
Shallow-focus earthquakes are the result of the sudden release of strain energy built up over time in rock by brittle fracture and frictional slip over planar surfaces. However, the physical mechanism of deep focus earthquakes is poorly understood. Subducted lithosphere subject to the pressure and temperature regime at depths greater than 300 km should not exhibit brittle behavior, but should rather respond to stress by plastic deformation. Several physical mechanisms have been proposed for the nucleation and propagation of deep-focus earthquakes; however, the exact process remains an outstanding problem in the field of deep-earth seismology.
The following four subsections outline proposals which could explain the physical mechanism allowing deep focus earthquakes to occur. With the exception of solid-solid phase transitions, the proposed theories for the focal mechanism of deep earthquakes hold equal footing in current scientific literature.
Solid-solid phase transitions
The earliest proposed mechanism for the generation of deep-focus earthquakes is an implosion due to a phase transition of material to a higher-density, lower-volume phase. The olivine-spinel phase transition is thought to occur at a depth of 410 km in the interior of the earth. This hypothesis proposes that metastable olivine in oceanic lithosphere subducted to depths greater than 410 km undergoes a sudden phase transition to spinel structure. The increase in density due to the reaction would cause an implosion giving rise to the earthquake. This mechanism has been largely discredited due to the lack of a significant isotropic signature in the moment tensor solution of deep-focus earthquakes.
Dehydration embrittlement
Dehydration reactions of mineral phases with high water content would increase the pore pressure in a subducted oceanic lithosphere. The increase in pore pressure is attributed to the release of fluids in-situ within the rock, thus raising its overall pressure. This effect reduces the effective normal stress in the slab and allows slip to occur on pre-existing fault planes at significantly greater depths than would normally be possible. Several workers suggest that this mechanism does not play a significant role in seismic activity beyond 350 km depth due to the fact that most dehydration reactions will have reached completion by a pressure corresponding to depths of 150–300 km (5-10 GPa).
Transformational faulting or anticrack faulting
Transformational faulting, also known as anticrack faulting, is the result of the phase transition of a mineral to a higher-density phase occurring in response to shear stress in a fine-grained shear zone. The transformation occurs along the plane of maximal shear stress. Rapid shearing can then occur along these planes of weakness, giving rise to an earthquake in a mechanism similar to a shallow-focus earthquake. Metastable olivine subducted past the olivine-wadsleyite transition at 320–410 km depth (depending on temperature) is a potential candidate for such instabilities. Arguments against this hypothesis include the requirements that the faulting region should be very cold, and contain very little mineral-bound hydroxyl. Higher temperatures or higher hydroxyl contents preclude the metastable preservation of olivine to the depths of the deepest earthquakes.
Shear instability / thermal runaway
A shear instability arises when heat is produced by plastic deformation faster than it can be conducted away. The result is thermal runaway, a positive feedback loop of heating, material weakening, and strain localisation within the shear zone. Continued weakening may result in partial melting along zones of maximal shear stress. Plastic shear instabilities leading to earthquakes have not been documented in nature, nor have they been observed in natural materials in the laboratory. Their relevance to deep earthquakes therefore lies in mathematical models which use simplified material properties and rheologies to simulate natural conditions.
Deep-focus earthquake zones
Major zones
Eastern Asia / Western Pacific
On the border of the Pacific plate and the Okhotsk and Philippine Sea plates is one of the most active deep-focus earthquake regions in the world, creating many large earthquakes including the 8.3 2013 Okhotsk Sea earthquake. As with many places, earthquakes in this region are caused by internal stresses on the subducted Pacific plate as it is pushed deeper into the mantle.
Philippines
A subduction zone makes up most of the border of Philippine Sea plate and Sunda plate, the fault being partially responsible for the uplift of the Philippines. The deepest sections of the Philippine Sea plate cause earthquakes as deep as 675 km below the surface. Notable deep-focus earthquakes in this region include a 7.7 earthquake in 1972 and the 7.6, 7.5, and 7.3 2010 Mindanao earthquakes.
Indonesia
The Australian plate subducts under the Sunda plate, creating uplift over much of southern Indonesia, as well as earthquakes at depths of up to 675 km. Notable deep-focus earthquakes in this region include a 7.9 earthquake in 1996 and a 7.5 earthquake in 2007.
Papua New Guinea / Fiji / New Zealand
By far the most active deep focus faulting zone in the world is that caused by the Pacific plate subducting under the Australian plate, Tonga plate, and Kermadec plate. Earthquakes have been recorded at depths of over 735 km, the deepest in the planet. The large area of subduction results in a broad swath of deep-focus earthquakes centered from Papua New Guinea to Fiji to New Zealand, although the angle of the plates' collision causes the area between Fiji and New Zealand to be the most active, with earthquakes of 4.0 or above occurring on an almost daily basis. Notable deep-focus earthquakes in this region include a 8.2 and 7.9 earthquake in 2018, and a 7.8 earthquake in 1919.
Andes
The subduction of the Nazca plate under the South American plate, in addition to creating the Andes mountain range, has also created a number of deep faults under the surfaces of Colombia, Peru, Brazil, Bolivia, Argentina, and even as far east as Paraguay. Earthquakes frequently occur in the region at depths of up to 670 km beneath the surface. Several large earthquakes have taken place here, including the 8.2 1994 Bolivia earthquake (631 km deep), the 8.0 1970 Colombia earthquake (645 km deep), and 7.9 1922 Peru earthquake (475 km deep).
Minor zones
Granada, Spain
Roughly 600-630 km under the city Granada in southern Spain, several large earthquakes have been recorded in modern history, notably including a 7.8 earthquake in 1954, and a 6.3 earthquake in 2010. The exact cause for the earthquakes remains enigmatic. More recent research analyzing the 2010 earthquake suggests that the seismic region is associated with a deep oceanic slab (the Alboran Slab) subducted by the converging African and Eurasian plates and flipping upside down in the process, trapping previously near-surface water-saturated rocks underneath it. The observed earthquakes then may be caused by hydrated magnesium silicates in the rock dehydrating and becoming more brittle. The level of hydration in the slab suggests it was subducted unusually fast given its depth, roughly 7 cm/yr.
Tyrrhenian Sea
The Tyrrhenian Sea west of Italy is host to a large number of deep-focus earthquakes as deep as 520 km below the surface. However, very few earthquakes occur in the region less than 100 km deep, the majority originating from a depth of around 250-300 km. Due to the lack of shallow earthquakes, the faulting is believed to originate from an ancient subduction zone that began subducting less than 15 million years ago, and largely finished around 10 million years ago, no longer visible on the surface. Due to the calculated subduction rate, the cause for subduction was likely to be internal stressing on the Eurasian plate, rather than due to the collision of the African and Eurasian plates, the cause of modern-day subduction for the nearby Aegean Sea and Anatolian microplates.
Afghanistan
In northeastern Afghanistan, a number of medium-intensity deep focus earthquakes of depths of up to 400 km occasionally occur. They are caused by the collision and subduction of the Indian plate under the Eurasian plate, the deepest earthquakes centered on the furthest-subducted sections of the plate.
South Sandwich Islands
The South Sandwich Islands between South America and Antarctica are host to a number of earthquakes up to 320 km in depth. They are caused by the subduction of the South American plate under the South Sandwich plate.
Notable deep-focus earthquakes
The strongest deep-focus earthquake in seismic record was the magnitude 8.3 Okhotsk Sea earthquake that occurred at a depth of 609 km in 2013. The deepest earthquake ever recorded was a small 4.2 earthquake in Vanuatu at a depth of 735.8 km in 2004. However, although unconfirmed, an aftershock of the 2015 Ogasawara earthquake was found to have occurred at a depth of 751 km.
References
References
- Frolich, Cliff. (1989). "The Nature of Deep-Focus Earthquakes". Annual Review of Earth and Planetary Sciences.
- Green, Harry W.. (995). "The mechanics of deep earthquakes". Annual Review of Earth and Planetary Sciences.
- (September 1969). "Mantle Earthquake Mechanisms and the Sinking of the Lithosphere". Nature.
- (July 1984). "The state of stress in subducting slabs as revealed by earthquakes analysed by moment tensor inversion". Earth and Planetary Science Letters.
- (December 2019). "Global Tectonics". John Wiley & Sons.
- Frohlich, Cliff. (December 2019). "Deep Earthquakes". Cambridge University Press.
- Condit, Cailey B.. (2020-12-15). "Slab dehydration in warm subduction zones at depths of episodic slip and tremor". Earth and Planetary Science Letters.
- "M 4.8 – Celebes Sea". United States Geological Survey.
- "M 4.6 – Banda Sea". United States Geological Survey.
- "M 4.2 – Vanuatu region". United States Geological Survey.
- "Latest Earthquakes". United States Geological Survey.
- (2015). "Open-File Report".
- "M 3.7 – Acre, Brazil". United States Geological Survey.
- "M 7.8 – Strait of Gibraltar". United States Geological Survey.
- "An Enigma Deep Beneath Spain". seismo.berkeley.edu.
- "Strange Seismic Wave Arrivals Lead to Discovery of Overturned Slab in the Mediterranean". Seismological Society of America.
- "M 3.7 – Tyrrhenian Sea". United States Geological Survey.
- (1 December 1987). "The deep seismicity of the Tyrrhenian Sea". Geophysical Journal International.
- "M 5.0 – 4 km SSE of Ashkasham, Afghanistan". United States Geological Survey.
- (26 October 2015). "Cause of Afghan Quake Is a Deep Mystery". National Geographic News.
- "M 4.3 – 132 km NNW of Bristol Island, South Sandwich Islands". United States Geological Survey.
- (July 2002). "Sediment subduction, subduction erosion, and strain regime in the northern South Sandwich forearc". Journal of Geophysical Research: Solid Earth.
- (2013-05-25). "M8.3 – Sea of Okhotsk". United States Geological Survey.
- "M 4.2 – Vanuatu region". United States Geological Survey.
- (October 26, 2021). "Deepest earthquake ever detected struck 467 miles beneath Japan". [[National Geographic]].
This article was imported from Wikipedia and is available under the Creative Commons Attribution-ShareAlike 4.0 License. Content has been adapted to SurfDoc format. Original contributors can be found on the article history page.
Ask Mako anything about Deep-focus earthquake — get instant answers, deeper analysis, and related topics.
Research with MakoFree with your Surf account
Create a free account to save articles, ask Mako questions, and organize your research.
Sign up freeThis content may have been generated or modified by AI. CloudSurf Software LLC is not responsible for the accuracy, completeness, or reliability of AI-generated content. Always verify important information from primary sources.
Report