Circumhorizontal arc

Formation

The halo is formed by sunlight entering horizontally-oriented, flat, hexagonal ice crystals through a vertical side face and leaving through the near horizontal bottom face (plate thickness does not affect the formation of the halo). In principle, Parry oriented column crystals may also produce the arc, although this is rare. The 90° inclination between the ray entrance and exit faces produce the well-separated spectral colours. The arc has a considerable angular extent and thus, rarely is complete. When only fragments of a cirrus cloud are in the appropriate sky and sun position, they may appear to shine with spectral colours.

Frequency

How often a circumhorizontal arc is seen depends on the location and the latitude of the observer. In the United States it is a relatively common halo, seen several times each summer in any one place. In contrast, it is a rare phenomenon in northern Europe for several reasons. Apart from the presence of ice-containing clouds in the right position in the sky, the halo requires that the light source (Sun or Moon) be very high in the sky, at an elevation of 58° or greater. This means that the solar variety of the halo is impossible to see at locations north of 55°N or south of 55°S. A lunar circumhorizon arc might be visible at other latitudes, but is much rarer since it requires a nearly full Moon to produce enough light. At other latitudes the solar circumhorizontal arc is visible, for a greater or lesser time, around the summer solstice. Slots of visibility for different latitudes and locations may be looked up here. For example, in London the sun is only high enough for 140 hours between mid-May and late July, whereas Los Angeles has the sun higher than 58 degrees for 670 hours between late March and late September.

Artificial circumhorizontal arcs

A water glass experiment (known about since at least 1920) may be modified slightly to create an artificial circumhorizontal arc. Illuminating under a very steep angle from below the side face of a nearly completely water-filled cylindrical glass will refract the light into the water. The glass should be situated at the edge of a table. The second refraction at the top water-air interface will then project a hyperbola at a vertical wall behind it. The overall refraction is then equivalent to the refraction through an upright hexagonal plate crystal when the rotational averaging is taken into account. A colorful artificial circumhorizontal arc will then appear projected on the wall. Using a spherical projection screen instead will result in a closer analogy to the natural halo counterpart. Other artificial halos can be created by similar means.

Similar optical phenomena

Circumhorizontal arcs, especially when only fragments can be seen, are sometimes confused with cloud iridescence. This phenomenon also causes clouds to appear multi-coloured, but it originates from diffraction (typically by liquid water droplets or ice crystals) rather than refraction. The two phenomena can be distinguished by several features. Firstly, a circumhorizon arc always has a fixed location in the sky in relation to the Sun or Moon (namely below it at an angle of 46°), while iridescence can occur in different positions (often directly around the Sun or Moon). Secondly, the colour bands in a circumhorizon arc always run horizontally with the red on top, while in iridescence they are much more random in sequence and shape, which roughly follows the contours of the cloud that causes it. Finally, the colours of a circumhorizon arc are pure and spectral (more so than in a rainbow), while the colours in cloud iridescence have a more washed-out, "mother of pearl" appearance.

Confusion with other members of the halo family, such as sun dogs or the circumzenithal arc, may also arise, but these are easily dismissed by their entirely different positions in relation to the Sun or Moon. More difficult is the distinction between the circumhorizontal arc and the infralateral arc, both of which almost entirely overlap when the Sun or Moon is at a high elevation. The difference is that the circumhorizontal arc always runs parallel to the horizon (although pictures typically show it as a curved line due to perspective distortion), whereas the infralateral arc curves upward at its ends.

Gallery

File:Halos Mexico.jpg|A circumscribed or 22° halo (top) together with a circumhorizon arc (bottom), photographed in Mexico File:Circumhorizontal arc in Michigan.jpg|Photographed in Ravenna, Michigan File:Ohlookarainbow.jpg|Photographed in Hocking Hills, Ohio File:Circumhorizon Arc in Alentejo, Portugal.jpg|Photographed in Alentejo, Portugal File:Circumhorizontal arc Banjarmasin Indonesia.png|Photographed in Banjarmasin, Indonesia File:CircumhorizonArcNCarolina.JPG|Photographed at Emerald Isle, North Carolina File:Circumhorizontal arc costa rica.jpg|Photographed in Tres Ríos, Costa Rica. File:Rainbow clouds pictured near Kennedy Space Center, Florida.jpg|Photographed near Kennedy Space Center, Florida File:Circumhorizontal arc lewisville tx.jpg|Photographed near Lewisville,Texas File:Fire Rainbow (Circumhorizontal Arc).jpg|Photographed in Wrightsville, Pennsylvania. File:Circumhorizontal Arc, Elk Ridge, Utah 02.jpg|Photographed near Elk Ridge, Utah File:An iridescent cirrus cloud in Silang, Cavite..jpg|Photographed in Silang, Cavite.

References

References

1. "OPOD - Moonlight Circumhorizon Arc".
2. Tape, Walter and Moilanen, Jarmo - 'Atmospheric Halos & the search for angle x', American geophysical Union,2006 - pp196-7
3. Les Cowley. "Circumhorizon arc". atoptics.co.uk.
4. (August 29, 2009). "Fire Rainbows". UC Santa Barbara Department of Geography.
5. Les Cowley. "Circumhorizon arc". Atmospheric Optics.
6. Markus Selmke and Sarah Selmke. (2017). "Artificial circumzenithal and circumhorizontal arcs". American Journal of Physics, Vol. 85, Issue 8, p.575-581.