From Surf Wiki (app.surf) — the open knowledge base
Asperity (geotechnical engineering)
In geotechnical engineering and contact mechanics the term asperity is used to refer to individual features of unevenness (roughness) of the surface of a discontinuity, grain, or particle with heights in the range from approximately 0.1 mm to the order of metres. Below the asperity level, surface interactions are normally considered to be a material property, arising from mechanisms of adhesion and repulsion at the atomic scale (often accounted for by material friction, atomic friction or molecular friction).
Dilation
An often used definition for asperities in geotechnical engineering:
Unevenness of a surface are asperities if these cause dilation if two blocks with in between a discontinuity with matching asperities on the two opposing surfaces (i.e. a fitting discontinuity) move relative to each other, under low stress levels that do not cause breaking of the asperities.
Contrast with asperity in materials science
Materials science recognizes asperities ranging from the sub-visual (normally less than 0.1 mm) to the atomic scale.
References
| book-title = Proc. 1st Congress of International Society for Rock Mechanics (ISRM) | editor1-last = Rocha | editor1-first = M.
This article was imported from Wikipedia and is available under the Creative Commons Attribution-ShareAlike 4.0 License. Content has been adapted to SurfDoc format. Original contributors can be found on the article history page.
Ask Mako anything about Asperity (geotechnical engineering) — get instant answers, deeper analysis, and related topics.
Research with MakoFree with your Surf account
Create a free account to save articles, ask Mako questions, and organize your research.
Sign up freeThis content may have been generated or modified by AI. CloudSurf Software LLC is not responsible for the accuracy, completeness, or reliability of AI-generated content. Always verify important information from primary sources.
Report