4-inch/50-caliber gun

Design

The original 4-inch/50-caliber Mark 7 gun, M1898, serial nos. 213–254, 257–281, 316–338, was an entirely new high-power design built-up gun with a tube, jacket, hoop, locking ring and screw breech. Gun No. 213 had a liner. The gun was described as a 5 in gun but with a 4-inch bore in the 1902 handbook, this indicated its higher power and also the fact the barrel was actually more the size of a 5-inch/40 caliber gun than a 4-inch gun. The ammunition was about 7 lbs heavier than a 4-inch/40 caliber round. The Mod 1 was a Mod 0 that used a conical steel liner and the Mod 2 was either a Mod 0 or Mod 1 that was relined using a conical nickel-steel liner and a shoulder on the breech end.

Gun No. 353 was the prototype of the Mark 8 and was test fired on 22 September 1910. This gun had been ordered 16 June 1907 and delivered in November 1907. The simplified design of the Mark 8 had just a gun tube and jacket. The jacket extended all the way to the muzzle and ended in a muzzle bell. The production run was small with only 12 guns built, Nos. 353–364.

The Mark 9 was a design directly resulting from tests with gun No. 353. It was designed to be light in weight, and would go on to be the standard 4-inch gun used on destroyers and submarines during WW I. The gun would use an A tube, full-length jacket, a muzzle swell with a side swing Smith-Asbury breech mechanism and Welin breech block. The gun weighed about 2.725 ST. Gun No. 365, the first Mark 9, was ordered from Midvale Steel on 18 October 1911. There were 390 Mark 9s built by four different manufacturers from 1911 until the US entered World War I in 1917. During the war another 1,885 guns were produced, with Root & VanDervoort, American Radiator Company and Poole Engineering joining the pre-war manufacturers. After the Armistice another 713 guns were produced, with orders for 3538 guns cancelled. It was decided after World War I that all destroyers would carry the 4-inch/50-caliber Mark 9 Mod 5 gun; the refits were completed in autumn 1921.

The Mark 10, gun No. 365-A, was ordered in 1915 but does not appear to have been completed until after WW I. The initial drawings were for a 4-inch/50-caliber anti-aircraft gun dated January and February 1915. It was designed with a vertically sliding breech block on a built-up gun with a tube, jacket, chase hoop and locking ring, all constructed of nickel steel, but it does not appear that the Mark 10 was put into service.

The gun was rapid firing (US term) or quick firing (British term). Fixed ammunition (case and projectile handled as a single assembled unit) with a 14.5 lb charge of smokeless powder gave a 33 lb projectile a velocity of 2900 ft/s. Range was 9 mi at the maximum elevation of 20 degrees. Useful life expectancy was 400–500 effective full charges (EFC) for a non-chrome plated barrel, while a chrome plated barrel was listed at 600 rounds.

Increasing awareness of the need for improved anti-aircraft protection resulted in the mounting of dual purpose guns on destroyers beginning in the 1930s. The dual-purpose 5-inch/38 caliber gun became standard for United States destroyers constructed from the 1930s through World War II. United States destroyers built with 4-inch/50-caliber low-angle guns were mostly rearmed with dual-purpose 3-inch/50 caliber guns during the war. The 4-inch/50-caliber guns removed from destroyers were mounted on Defensively Equipped Merchant Ships of the British Merchant Navy and United States Merchant Marine like . As S-boats were transferred from combat patrols to training duties from mid-1942 through 1943, their 4-inch guns were removed and used to re-equip front-line submarines built with 3-inch/50-caliber guns.

Manufacturer list Mark 9 gun

The unassigned numbers mostly corresponded to gun orders that were cancelled with the signing of the Armistice.

US Navy service

The 4″/50-caliber gun was mounted on:

• s (Mark 7)
• s
• s
• s
• s
• s
• s
• s
• s
• s
• The first seven s
• Numerous rearmed submarines including , , , and
• Some minesweepers - Q-ships like
• Some minelayers like
• Some patrol gunboats like , ,
• armed yachts,

United States Merchant Marine

• Most Liberty ships
• World War I underway replenishment oilers like
• Some World War II oilers like , and

Coast defense use

Four two-gun batteries of 4″/50-caliber ex-Navy guns were emplaced on the North Shore of Oahu in 1942. They seem to have been withdrawn in 1943 as other defenses were constructed. It is not clear who operated these guns; likely possibilities include the United States Army Coast Artillery Corps, Marine defense battalions, or naval personnel. The batteries were at Kaena, Kalihi (Mokuoeo Island), Battery Dillingham at Mokuleia, and Kaneohe Bay.

UK service

Many Mark 9 guns were supplied to the United Kingdom during World War II as part of Lend-lease, both individually and on naval and merchant ships. Caldwell, Wickes, and Clemson-class destroyers transferred under the Destroyers for Bases Agreement became British and Canadian s.

Notes

References

• DiGiulian, Tony, United States of America 4″/50 (10.2 cm) Marks 7, 8, 9 and 10 at Navweaps.com
• Gardiner, Robert and Gray, Randal, Conway's All the World's Fighting Ships 1906-1921 Conway Maritime Press, 1985. .

References

1. Campbell 1985 p.143
2. Fairfield 1921 p.156
3. Friedman, Norman. (2011). "Naval Weapons of World War One". Seaforth Publishing.
4. Gardiner and Gray pp. 122-123
5. Fahey 1939 p.14
6. Fahey 1939 p.18
7. Berhow, p. 221
8. Di Giulian
9. Lenton and Colledge 1968 pp.90-92