From Surf Wiki (app.surf) — the open knowledge base
Sinking (metalworking)
Sinking, also known as doming, dishing or dapping, is a metalworking technique whereby flat sheet metal is formed into a non-flat object by hammering it into a concave indentation. While sinking is a relatively fast method, it results in stretching and therefore thinning the metal, risking failure of the metal if it is "sunk" too far.
Rendering article…
Content sourced from manual.
This content may have been generated or modified by AI, and may be sourced from third parties. CloudSurf Software LLC makes no warranties as to its accuracy, completeness, or reliability, and accepts no liability for it. Always verify important information against primary sources.
Report